Control-company 4115 RADIO-SIGNAL REMOTE THERMOMETER Manual de usuario

TRACEABLE® RADIO-SIGNALREMOTE THERMOMETERINSTRUCTIONS

10If no signals are received, blanks “- - -” will be displayed and the kinetic wave icon will show “ ”. Press CHANNEL and MEM simultaneously to force

11HOW TO READ THE KINETIC WAVE DISPLAYThe kinetic wave display shows the signal receiving status of the main unit. There are three possible forms.MAXI

123. Use the ADVANCE (s) button to set the upper or lower temperature. If this is the first time setting limits, the lower limit will start from -58

13Note: When the temperature falls below the freezing point, the batteries of outdoor remotes will freeze, lowering their voltage supply and effective

14The remote unit comes with a wall-mount holder and a removable stand. Use either to hold the unit in place.THE RESET BUTTONThis button is only used

154. Do not tamper with the unit’s internal components. Doing so will invali-date the warranty on the unit and may cause unnecessary damage. The unit

16Remove the back panel of the remote transmitter. Remove the batteries, wait 20 seconds, and put them back in the unit. Then, using a stylus or strai

17On occasion, momentary interference with the remote transmitter may cause an erroneous minimum or maximum reading to be captured by the main unit.If

ACCESSORIESControl Cat. No. 4116 Additional Traceable® Remote Sensor Module with internal and external probe. (May be set to Channel 1, 2, or 3. Tota

2SPECIFICATIONSDisplay— Main unit: two-line 1" LCD Remote unit: 3/8" LCDTemperature— Main unit IN range: –9.9 to 158.0°F (–9.9 to 70.0°

3FEATURES• The unit is an easy-to-use, state-of-the-art thermometer. The basic pack-age comes with a main unit, which is the temperature receiver, an

4Figure 1 Main unit configuration

5QUICK REFERENCEMain Unit (see fig. 1)A. EXTRA-LARGE LCD Facilitates easy reading of remote and indoor temperatures.B. CHANNEL button Selects among

6Figure 2 Remote unit configurationRemote Unit (see fig. 2)A. LCD Displays the current temperature monitored by the remote unit.B. LED indicator Fl

7C. °C/°F switch Selects between Celsius (°C) and Fahrenheit (°F).D. CHANNEL switch Designates the remote unit Channel 1, Channel 2 or Channel 3.E.

83. Select the temperature display unit on the °C/°F slide switch.4. Insert the batteries strictly according to the polarities shown.5. Replace the

93. Replace the battery compartment door.Replace the batteries when the low-battery indicator of the indoor tempera-ture lights up. (Repeat the steps